XADO Anticarbon Cleaning the engine from carbon 320ml 10.82oz

Anticarbon
Cleaning the engine from carbon.
High-speed product designed to remove carbon contaminants and repair stuck piston rings for gasoline and diesel engines.

Removes all scale and dirt from the surfaces of parts of the cylinder-piston system.

Does not require oil change after application.

Applications
1. Warm up the engine. The engine must be warm but not hot.
2. Unscrew the plugs (torch). Disconnect the ignition timing sensor, Hall sensor or switch wire.
3. Insert the contents of 1 tube into each cylinder through the plug hole. Screw the plugs back. Wait 10–20 minutes. Turn off the plugs. Cover the holes with an absorbent cloth to avoid dirt on the paint. Rotate the engine with the starter for a few seconds.
4. Install the plugs (burners) in place.
5. Start the engine and let it run at an increased crankshaft rotational speed for 15-20 minutes. During this time, residues of softened coal will be removed through the exhaust system.
dosage
1 tube - 1 cylinder.

Notes
Avoid contact with the paintwork.
Safe for catalytic converters, oxygen sensors, rubber products and seals.

VERYLUBE Anticarbon in tubes can be used to flush the engine oil system:

1. Enter the anti-carbon into the heated engine through the oil filler neck in the ratio of 40 ml of anti-carbon to 3-5 liters of oil.
2. Let the engine idle for 10-“15 minutes.
3. Change the oil and oil filter.