PERMATEX Water Pump & Thermostat RTV Silicone Gasket Maker 14g

Silicone Gasket-Sealant For Water
Pumps and Thermostats is one-piece
its composition, vulcanizing at room
temperature with a gasket designed for
mechanical installation of auto gaskets, finally
formed in the working position. Substance, from
which the gasket consists of, vulcanized when
interaction with moisture in the air, forming a dense,
a plastic gasket made of silicone rubber.
After vulcanization, the gasket successfully resists
unfavorable weather and temperature conditions,
without hardening, not shrinking or cracking. Provides
high degree of protection against water-based glycols,
which is typical for most silicone adhesive sealants, vulcanizing at room
temperature.
PRODUCT ADVANTAGES
• Safe for sensors, non-corrosive
• Excellent adhesive formula and plasticity
• Ease of use
• Can be used as a substitute
most common gaskets
• Can be used as a spacer or
sealant
• Not fire hazardous
• Non-toxic
USED ​​FOR PROCESSING:
• Housings of thermostats
• Water pumps
INSTRUCTIONS FOR USE
For mounting gaskets, permanently formed
in working position
1. Remove remnants of old parts from the assembly
surface. For these purposes, you can use
Permatex Gasket Remover
Gasket Remover,
which is suitable for all materials for
excluding plastics and painted
surfaces.
2. For best results, you must
clean and dry surfaces with
solvent free of sediment, for example with
with Brake and Parts Cleaner
Permatex
Brake and Parts Cleaner.
3. Cut the cap to get the hole
required diameter - from 0.15875 cm (1/16
in) to 0.635 cm (1/4 in). Most convenient and
a 0.3175 cm diameter hole is often used
(1/8 inch).
4. Remove the cap, pierce the safety
the valve on the neck of the tube or cartridge and put on
cap with pre-formed
hole of the required diameter.
5. Apply gasket continuously and evenly
a layer on one of the surfaces, primarily along the inner perimeter of the gasket being formed,
and, then, along the outer perimeter - around the holes
and bolts as shown below:
6. Immediately mount the parts while
the silicone substance of the gasket remains
wet. Fasten or tighten the parts (in
compliance with the requirements of TU).
7. After the gasket is completely dry, re-tighten
no details required.
For sealing conventional gaskets
1. Repeat steps 1 - 4 as described above.
2. Apply silicone to one of the sealed
surfaces.
3. Place the gasket on the silicone layer.
4. Apply a thin layer of silicone to the top
gasket surfaces.
5. Immediately remove excess silicone.
Attention: This product is not recommended
use as a gasket or sealant
cylinder heads.